GSDS Home

Introduction

What's new in WellSim

FAQ

What is WellSim ?

Tutorials

Getting familiar with WellSim

Entering well geometry

Entering well data

Discharge simulations

Improving a discharge simulation

Output simulations

Tips for using WellSim

Changing how WellSim looks

Reservoir drawdown simulation

Injection simulations

Injectivity simulations

Advanced simulations

Reference

How WellSim works

Managing databases

Graphs

Exporting data

Importing data

Units

Preferences

References

Glossary

Installing WellSim

For evaluation

Setup with a key

On another PC

Upgrading WellSim

Registration

Single-user dongle

Network dongle

Uninstalling

Installing a single user dongle

Do not plug the dongle into your computer until you are told to.

1. Download the single user dongle test program VerifyKey.exe, in case you need it for troubleshooting.

2. Download the dongle installation program Install12062022.exe.

3. Run the dongle installation program Install12062022.exe. You should see:

   

4. Select KEYLOK 2 (USB w/Driver) and Standalone. Click Begin Install. You should see:

   

   If you do not see this, it is likely that drivers have already been installed. In this case, go to the Windows control panel and uninstall the drivers; then start this again.

5. The Device Drive Installation Wizard is displayed:

   

6. Click Next. The device drivers are installed and you might see this:

   

   Then:

   

7. Click Finish. You should see:

   

   Do not click Close yet. Plug the dongle into a USB port on your computer. Still do not click Close. Wait for a few seconds as the device drivers are installed; you may see this notification:

   

8. Once the drivers have been installed, now click Close, and you are ready to go.

Troubleshooting single user dongle problems

Run VerifyKey.exe (downlaaded above) to check that the computer can see the dongle.